CENTERFIRE
Laser Series
for Smith &Wesson
®
M&P Shield
™ 9mm/.40cal
Installation Instructions
Make sure the rearm is unloaded by removing the magazine and clearing
the chamber. Visually and physically check to ensure it is empty. Check again.
Install the battery () with the negative (–) side up, positive (+) side against
the spring. (One / Lithium included, or Two Silver Oxide batteries).
Align the channel in the Right Housing with the trigger guard of
the rearm. e top of the laser housing should sit ush to the
frame of the rearm (). Push the trigger guard into the channel,
and push up on the Guard Tab to snap into place ().
Assemble the laser housing by angling the rear of the Le Housing °
to lock it into place. en close the two halves together. ().
Make sure activation switch is through hole in housing. Squeeze the two
halves together with ngers so there is no gap, then insert the self tapping
screws into the laser housing. Hand tighten the screws with Phillips head
screwdriver until they rmly set ().
1
2
3
4
5
[–]
[+]
Insert trigger
guard into
channel
Push
to snap
into place
Make sure
activation switch
is through hole
in housing, then
squeeze together
until no gap,
then insert and
tighten screws
See it installed at
www.LaserMax.com
or nd it on
°
Operating Instructions
Activate the laser by pushing in on the activation switch
from either side (center position is ).
Activation
Windage
Elevation
Laser Aperture
Figure
Adjustments, Warning and
Cleaning Procedures
Check Alignment (Refer to gure A for location of windage & elevation ports).
To check for proper alignment, turn laser on and check laser position
relative to iron sights at – yards. e laser dot should be centered
slightly above the top of your iron sights.
Adjust Alignment
If laser needs adjustment, while pointing downrange, turn windage screw
clockwise to move laser le, counterclockwise () to move laser right.
Turn elevation screw clockwise to move laser up, to move the laser down
into the proper alignment.
A slight shi in alignment may be noticed aer ring the rst few rounds aer
installing the CenterFire™ . Recheck alignment and readjust if necessary.
WARNING:
Do not turn alignment screws more than ½ turn in either direction from factory
position. is may cause damage to the CenterFire™ and may void your warranty.
Cleaning
Over time and aer numerous rounds of ammunition, your laser lens could
become clouded with gun shot residue. In order to remove this residue:
Keep rearm pointed in a safe direction. Be sure to unload your rearm
by removing the magazine and clear any rounds in the chamber keeping
hands from passing in front of the muzzle. Conrm laser is o.
Take a standard cotton swab and dampen end with isopropyl alcohol.
Apply dampened swab to the laser lens, and rotate in a small circular pattern
removing any residue. Be sure to clean around the edges of the lens.
For best results, it’s recommended that the laser lens is cleaned at
the end of each day you shoot – similar to routine rearm cleaning.
•
•
•
*
Spare Parts List:
–
–
–
/
Patent Pending
01785–0–40
05/15/12
™
Easy To Use, Easy To Install
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels